Universal Integrated Furnace Control offers universal compatibility and diagnostics. It replaces a large number of furnace control models in single-stage warm air furnaces. Uses 120Vac hot surface igniter. Includes instructions and special wire harnesses for easy replacement

Cross reference and wire harnesses provided for simple replacement over 195 existing furnace controls

Main burner ignition using a 120V hot surface igniter

Flame rectification circuit to monitor flame presence

Monitoring of system pressure switch, high temperature limit, and rollout functions

Appliance operation/safety requirements controlled via microprocessor

Controls circulating fan motor based on appliance requirements, in response to a conventional low voltage thermostat

LED system status, performance and diagnostic indication

Twinning capability

Compact-Smaller footprint allows for a better fit and easier installation

Universal-One defrost control for nearly every single stage heat pump to reduce inventory and increase profitability

This universal control replaces more than 260 OEM and competitive models

Easy Setup-Save time with a dual LED display that simplifies configuration

Quite Mode-Customers will appreciate the quiet operation

Replaces over 400 White-Rogers, Robertshaw and Honeywell intermittent pilot ignition modules

Provides ignition sequencing, flame monitoring and safety shutoff for intermittent pilot warm air furnaces and heating appliances

Provides 100% pilot gas shutoff if pilot fails to light

After 6-minute delay, trial for ignition is repeated

Ignition trial/delay sequence is repeated until the appliance lights or call for heat is removed

For use with Natural or LP gas

For use in single rod or dual rod/remote sense applications

Includes spark cable adapters to allow field replacement of both Honeywell and competitive controls without replacing existing spark cable

S8910U 3000 Series has LED Status Indicator and Microammeter Ports for Easy Troubleshooting

For Local (Single Rod) or Remote (Dual Rod) Rectification Type Flame Sensing

Contains Easy-To-Use Cross Reference and Instructions Plus the Accessories Required to Replace the Existing Hot Surface Ignition Module

24 VAC microprocessor based IPI control

System diagnostics

32 Selectable preset timings of popular models

Universal flame sensing (Local/Internal or Remote/External)

Full time flame sensing

Flame sense test pins

4 mounting hole positions, 2 that match Honeywell and Fenwal

Built-in burner ground

Voltage/Frequency monitoring

Made in USA