In-Line Draft Inducers Assure Positive Draft when Restricted Boilers and Furnaces, Poor Chimneys or Negative Pressures in Buildings Prevent Proper Exhaust of Combustion Gases

In-Line Inducers are Built for Long Lasting, Trouble-Free Service

Made in USA

Use to Interlock with Self-Generated Millivolt Gas Water Heaters

Includes a Gas Pressure Switch to Sense Main Burner Operation, a Linear Limit Flue Gas Spill Switch and a Thermocouple Junction Adapter to Tie into the Heater's Thermocouple Circuit

Made in USA

Quiet Operation

Factory Wired for Fast, Safe Installation

Safety Controls Shut Off Heater if Vent System Fails

Post-Purge Timer Keeps Power Venter Operating After Burner Cycle to Purge System of Residual Gases

Outlasts most Water Heater in Hard Water Areas

Locate Heater anywhere up to 75 Equivalent Feet from Outside Wall

No Electrician Needed for Installation

Use in Tandem with High Efficiency, Direct Vent Furnaces

Made in USA

Quiet Operation

Factory Wired for Fast, Safe Installation

Safety Controls Shut Off Heater if Vent System Fails

Post-Purge Timer Keeps Power Venter Operating After Burner Cycle to Purge System of Residual Gases

Outlasts Most Water Heater in Hard Water Areas

Locate Heater anywhere up to 75 Equivalent Feet from Outside Wall

No Electrician Needed for Installation

Use in Tandem with High Efficiency, Direct Vent Furnaces

Made in USA

Adjustable pre and post purge

LED status/diagnostic indicators

Selectable voltage to avoid false triggering by electronic burner controls

Prover switch check circuit to verify that the fan prover switch is open prior to operation

A 10-second prover switch delay to eliminate burner start up or wind induced prover switch short cycling

A 5 VDC Control supplied fan prover signal that isolates the burner load circuit from the prover switch circuit

RoHS Compliant

Prefastened Multi Fit, Break Off Mounting Bracket

Impedance Protected

Includes all Mounting Accessories and Hardware

Reversible Rotation

Single Speed