Controls Gas Valve, Igniter, Blower Motor, Inducer, Humidifier and Air Cleaner

Microprocessor-Based Precision

Designed for 100 Percent Gas Shut-Off in Case of Ignition Failure

Twinning Compatible with Another ICM2807 Control

Reverse Polarity Protection

Secondary Brownout Voltage Protection

Compatible with 24 Volt AC Standard Thermostat

Continuous Blower Speed Jumper

Limit Switch Lockout Time

Limit Switch Lockout after Power Interruption

Self-Diagnostics

Provides Diagnostic LEDs to Aid in Troubleshooting

Made in USA

Low Cost Form

Microprocessor-Based Precision

Diagnostic Leds Aid in Testing and Troubleshooting

Made in USA

Universal Integrated Furnace Control offers universal compatibility and diagnostics. It replaces a large number of furnace control models in single-stage warm air furnaces. Uses 120Vac hot surface igniter. Includes instructions and special wire harnesses for easy replacement

Cross reference and wire harnesses provided for simple replacement over 195 existing furnace controls

Main burner ignition using a 120V hot surface igniter

Flame rectification circuit to monitor flame presence

Monitoring of system pressure switch, high temperature limit, and rollout functions

Appliance operation/safety requirements controlled via microprocessor

Controls circulating fan motor based on appliance requirements, in response to a conventional low voltage thermostat

LED system status, performance and diagnostic indication

Twinning capability

Compact-Smaller footprint allows for a better fit and easier installation

Universal-One defrost control for nearly every single stage heat pump to reduce inventory and increase profitability

This universal control replaces more than 260 OEM and competitive models

Easy Setup-Save time with a dual LED display that simplifies configuration

Quite Mode-Customers will appreciate the quiet operation

Replaces over 400 White-Rogers, Robertshaw and Honeywell intermittent pilot ignition modules

Provides ignition sequencing, flame monitoring and safety shutoff for intermittent pilot warm air furnaces and heating appliances

Provides 100% pilot gas shutoff if pilot fails to light

After 6-minute delay, trial for ignition is repeated

Ignition trial/delay sequence is repeated until the appliance lights or call for heat is removed

For use with Natural or LP gas

For use in single rod or dual rod/remote sense applications

Includes spark cable adapters to allow field replacement of both Honeywell and competitive controls without replacing existing spark cable

S8910U 3000 Series has LED Status Indicator and Microammeter Ports for Easy Troubleshooting

For Local (Single Rod) or Remote (Dual Rod) Rectification Type Flame Sensing

Contains Easy-To-Use Cross Reference and Instructions Plus the Accessories Required to Replace the Existing Hot Surface Ignition Module

Low Cost

Controls Inducer and Blower Fan Motor, Hot Surface Igniter and Gas Valve

Monitors Timing, Trial for Ignition, Flame Sensing, Pressure and Limit Switch and Lockout

Designed for 100 Percent Gas Shutoff in Case of Ignition Failure

Reverse Polarity Protection

Compatible with 24 Volt AC Standard Thermostat

Compatible with LP or Natural Gas

Provides Diagnostic LED to Aid in Testing or Troubleshooting

Made in USA

Controls Inducer and Blower Control

Designed for 100 Percent Gas Shutoff in Case of Ignition Failure

Monitors Timing and Gas Valve

Made in USA