CLS Series hoses feature a secure seal fitting that opens to full flow

The revolutionary patent-pending design on our internal structure significantly reduces blowouts, provides maximum flow and automatically traps refrigerant discharge in the hose

The gasket features a hood with a straight edge that snaps into the straight edge of the barb

This straight edge to straight edge force eliminates gasket blowouts

The depressor is barbed and locks into the gasket, meaning the outward force on the depressor pushes the gasket further into place, resulting in no blowouts

JB also uses a common crimp that grips the full circumference of the hose yielding a maximum hold and uniform seal that prevents leaks and bursts

Kobra® high pressure hoses are made from Kevlar® the same material that stops bullets in bullet proof vests

This provides a 5 to 1 safety factor (better than the industry standard of 4 to 1)

Kevlar® makes our hoses incredibly strong and flexible

Kobra® hoses feature a nitrile cover which is better than neoprene because it is more resistant to oil, giving the hoses a longer life

Pressure rating 800 psi and 4,000 psi burst

These hoses are suitable for R-410A and can be used with all common refrigerants except ammonia

Made in USA

Contractor Quality

118 Degree Conventional Point Angle Allows Deep Drilling in a Variety of Materials Including Metal

Lifetime Limited Warranty

Split Point Tip (132 Degree) makes pre-drilling obsolete and stays sharper longer resulting in increased speed, maximum durability and up to 6X longer life

Automated Precision CNC Grinding Process delivers strict angle tolerances on each step for minimal bit wear and 2X faster cuts in drilling and hole making

Exclusive design delivers corded and cordless tool efficiency in high-speed mode for up to 75% more holes per battery charge

1/4 Inch hex shank allows use with drills and impact drivers

Optimized dual flute design for jam-free cuts

Increased step heights for easier drilling of common hole sizes

Easy to read, laser marked steps for drilling holes of varying sizes

Two wings will reach out to switches that are set apart from a flat metal surface

A must in the tool box

This Handy Tool will Help to Pop out Molex and Amp Electrical Pins in Igniter and other Connectors