PVC Bend Guides Provide Protection at Slab Penetrations and Create Professional Appearance at Manifold

Gray Position Indicator Provides Visual Verification of the Actuators Position

Red Pull-Out Tab is Provided to Allow Easy Installation onto the Manifold After Installation

A Dry-Contact end Switch is Built into the Actuator

This End Switch Can be Used to Operate 24 VAC 2 Amps Max Relays for Pumps and Other Devices and Can be Wired so that Pumps Turn on Only when Actuator is Fully Open

RAUPEX Horizontal Uncoiler Folds for Convenient Transportation to Job Sites

Non-Abrasive Nylon Pipe Ties Safely Secure Pipe Directly to Slab Reinforcing Bars or Wire Mesh

RAUTACKER 3D foam staples are used when installing RAUPEX pipe on rigid foam board insulation in radiant heating and snow and ice melting applications

RAUTACKER 3D foam staples are used when installing RAUPEX pipe on rigid foam board insulation in radiant heating and snow and ice melting applications

RAUTACKER 3D 2-3/8 inch staples are required for 3/4 inch pipe and minimum 1-1/2 inch thick insulation, but also work with 3/8, 1/2 and 5/8 inch pipe

Typically, one staple is required every 3 foot on straight runs of pipe with an additional staple in the middle of bends