S2K Commerce - Products Dropdown
Actions
S2K Commerce - Order Entry
Actions
Front Diagnostic Lights
Switchable Priority
Built-In Priority Protection
Simplified Wiring
Premium Sealed Relays
Compact Design
Fuse Protected
100 Percent Factory Tested
Isolated End Switch
Contractor Friendly PC Board Layout
Universal Thermostat Compatibility
24 Volt Power Output for Hard Wired Thermostats
Field Replaceable Transformer
UL Approved
Made in USA
Front Diagnostic Lights
Switchable Priority
Built-In Priority Protection
Simplified Wiring
Premium Sealed Relays
Compact Design
Fuse Protected
100 Percent Factory Tested
Isolated End Switch
Contractor Friendly PC Board Layout
Universal Thermostat Compatibility
24 Volt Power Output for Hard Wired Thermostats
Field Replaceable Transformer
UL Approved
Made in USA
A pre-charged air chamber allows for system water expansion
The air charge is controlled via a charging valve located on the top or bottom of the tank
Additionally, both tank lines' diaphragms are oversized, which maximizes drawdown and minimizes wear
This design feature virtually eliminates diaphragm stretch, further promoting longevity
The pump is of the canned rotor type, i.e. pump and motor form an integral unit without shaft seal and with only two gaskets for sealing The bearings are lubricated by the pumped liquid
Integral Flow Check-Prevents gravity flow, Eliminates separate in-line flow check
Reduces installed cost, easy to service
Improved performance versus In-line flow checks
Unique replaceable cartridge-Field serviceable
Unmatched reliability-Maintenance-free
Quiet, efficient operation
Direct drive-Low power consumption
Self-lubricating, No mechanical seal
Standard high capacity output-Compact design
Wide range of applications
Lead-Free
Field-adjustable dwell-feed cycles
Multi-color LED status indicator
Hard-stop limit to minimize chances of flooding the boiler
Compatible with all electronic and mechanical
Low Water Cut Offs
Removable strainer (replace after cleaning)
Controls excess flow in the system when there is reduction in demand
All brass body with non-ferrous internals
For low pressure steam boilers with cold water feed
Eliminates necessity to manually add water to the boiler
Eliminates necessity to manually add water to the boiler
Can be used with mechanical or electronic low water Cut Off controls
Quick-change replaceable cartridge valve and strainer
The pump is of the canned rotor type, i.e. pump and motor form an integral unit without shaft seal and with only two gaskets for sealing The bearings are lubricated by the pumped liquid
Quick and easy installation
Whisper quiet operation
Built-in timer, line-cord and aquastat