Use with Honeywell Flame Safeguard Primary Safety Controls and Burners Requiring Ultraviolet Flame Detection

C7027 Mounts on a 1/2 Inch Sighting Pipe by Using an Integral Collar

Detectors Can be Wired in Parallel for Difficult Sighting Applications

C7027 Seals Against Pressures up to 5 PSI When Correctly Installed

Allows for Blast Tube Mounting Due to Compact Size

HotRod EX Replaces Replaces Over 200 Igniter Models

Robust Nitride Igniter Design for Longer Life and Fewer Callbacks

Nitride Igniters with 14.5 Inch and 15.5 Inch Leads-Stripped Ends

Universal and Standard Mounting Brackets and 2 Ceramic Wire Nuts

Replaces Most Silicon Carbide Igniters Including Many Carborundum Carbide Application

The Small Size of these Devices Enable their Application to Flame Detection in Installations where Space is Limited

the Holder and Flame rod Assemblies Facilitate Flame Proving on Gas Burners or Gas Ignited Oil Burners which are Controlled by Electronic Flame Safeguard Systems

Use on Industrial Flame-Retention Gas Burner Nozzles

Works with Honeywell Flame Safeguard Controls Requiring Rectification Type Flame Detector

Mounts in Areas with Limited Space Because Flame Rod Can be Cut to Desired Length

Uses Rajah Electrical Connector

Push-In Clip, Split Nut and Adapter Assembly for Easy Pilot Burner Installation

Male Nut Connector for Pilotstat Safety Control Power Units

Push-In Clip, Split Nut and Adapter Assembly for Easy Pilot Burner Installation

Male Nut Connector for Pilotstat Safety Control Power Units

Proven, Reliable Temperature Control

Many Flexible Versions to Meet Your Application Needs

Panels Can be Used with Staged Gas, Oil or Electric Heat

Modulating Gas, Hot Water or Steam Heat and Direct Expansion or Modulating Chilled Water Cooling

Control up to 3 On-Off Heat or Cool Stages or up to 10 On-Off Heat and/or Cool Stages Using W975 Satellite Sequencers

Modulating Dc Current Signal Controls Economizer Heating or Cooling Valve Motors

T7067 Dual Set Point Thermostat/Transmitter Located in Controlled Space Provides Heating and Cooling Input Signal Based on Space Demand

C7046A Sensor Located in Discharge Air Duct Provides Heating/Cooling Anticipation and Economizer Modulating Low Limit Signal

System Cycles All Stages Off on Power Interruption

When Power is Restored, System Sequences Required Stages on with Timed Inter-Stage Delay

Push-In Clip, Split Nut and Adapter Assembly for Easy Pilot Burner Installation

Male Nut Connector for Pilotstat Safety Control Power Units

Push-In Clip, Split Nut and Adapter Assembly for Easy Pilot Burner Installation

Male Nut Connector for Pilotstat Safety Control Power Units